H3C S3610-28P Operation Manual page 1168

Operation Manual – SNMP-RMON
H3C S3610&S5510 Series Ethernet Switches
To do...
Set to enable the
device to send Traps
of interface state
change
Caution:
To enable an interface to send SNMP Traps when its state changes, you need to
enable the Link up/down Trap packet transmission function on an interface and globally.
Use the enable snmp trap updown command to enable this function on an interface,
and use the snmp-agent trap enable [ standard [ linkdown | linkup ] * ] command to
enable this function globally.
II. Configuring Trap transmission parameters
Follow these steps to configure Trap:
Enter system view
Configure target host
attribute for Traps
Configure the source
address for Traps
Extend the standard
linkUp/linkDown Traps
defined in RFC
Configure the queue size
for sending Traps
enable snmp trap updown
To do...
system-view
snmp-agent target-host
trap address
udp-domain { ip-address
| ipv6 ipv6-address }
[ udp-port port-number ]
[ vpn-instance
vpn-instance-name ]
params securityname
security-string [ v1 | v2c |
v3 [ authentication |
privacy ] ]
snmp-agent trap source
interface-type
{ interface-number |
interface-number.subnum
ber }
snmp-agent trap if-mib
link extended
snmp-agent trap
queue-size size
Use the command...
Use the command...
1-7
Chapter 1 SNMP Configuration
Remarks
Optional
Enabled by
default.
Remarks
—
Required
The vpn-instance
keyword is applicable in a
network supporting IPv4.
Optional
Optional
Standard linkUp/linkDown
Traps defined in RFC are
used by default.
Optional
100 by default