H3C S3610-28P Operation Manual page 1363

Operation Manual – VRRP
H3C S3610&S5510 Series Ethernet Switches
II. Network diagram
Gateway:
FE80::10
Host A
Figure 1-10 Network diagram for single VRRP standby group configuration
III. Configuration procedure
1) Configure Switch A
# Configure VLAN 2.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] vlan 2
[SwitchA-vlan2] port GigabitEthernet 2/0/5
[SwitchA-vlan2] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address fe80::1 link-local
[SwitchA-Vlan-interface2] ipv6 address 1::1 64
# Create a standby group 1 and set its virtual IP address to FE80::10.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Set the priority of Switch A in standby group 1 to 110.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 110
# Set Switch A to work in preemption mode.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode
# Enable Switch A to send RA messages.
[SwitchA-Vlan-interface2] undo ipv6 nd ra halt
2) Configure Switch B
# Configure VLAN 2.
<SwitchB> system-view
[SwitchB] ipv6
Virtual IPv6 address:
FE80::10
Vlan-int2
FE80::1
Switch A
Vlan-int2
FE80::2
Switch B
1-30
Chapter 1 VRRP Configuration
Internet
Host B