H3C S3610-28P Operation Manual page 735

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
2) Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable
MLD on Ethernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/0/1
[RouterA-Ethernet1/0/1] mld enable
[RouterA-Ethernet1/0/1] pim ipv6 dm
[RouterA-Ethernet1/0/1] quit
[RouterA] interface ethernet 1/0/2
[RouterA-Ethernet1/0/2] pim ipv6 dm
[RouterA-Ethernet1/0/2] quit
3) Configure Switch A
# Enable MLD Snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign Ethernet 1/0/1 through Ethernet 1/0/4 to this VLAN, and
enable MLD Snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/0/1 to ethernet 1/0/4
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] quit
# Enable simulated (S, G) joining on Ethernet 1/0/3 and Ethernet 1/0/4.
[SwitchA] interface ethernet 1/0/3
[SwitchA-Ethernet1/0/3] mld-snooping host-join ff1e::101 vlan 100
[SwitchA-Ethernet1/0/3] quit
[SwitchA] interface ethernet 1/0/4
[SwitchA-Ethernet1/0/4] mld-snooping host-join ff1e::101 vlan 100
[SwitchA-Ethernet1/0/4] quit
4) Verify the configuration
# View the detailed information about MLD Snooping forwarding table entries in VLAN
100 on Switch A.
[SwitchA] display mld-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Chapter 3 MLD Snooping Configuration
3-22