Configuring Ripng Timers - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches

2.4.1 Configuring RIPng Timers

You can adjust RIPng timers to optimize the performance of the RIPng network.
Follow these steps to configure RIPng timers:
To do...
Enter system view
Enter RIPng view
Configure RIPng
timers
Note:
When adjusting RIPng timers, you should consider the network performance and
perform unified configurations on routers running RIPng to avoid unnecessary network
traffic increase or route oscillation.
2.4.2 Configuring Split Horizon and Poison Reverse
Note:
If both the split horizon and poison reverse are configured, only the poison reverse
function takes effect.
I. Configure the split horizon
The split horizon function disables a route learned from an interface from being
advertised via the interface to prevent routing loops between neighbors.
Use the command...
system-view
ripng [ process-id ]
timers
{ garbage-collect
garbage-collect-value
| suppress
suppress-value |
timeout timeout-value
| update
update-value } *
2-8
Chapter 2 IPv6 RIPng Configuration
Remarks
—
—
Optional.
The RIPng timers have the following
defaults:
30 seconds for the update timer
180 seconds for the timeout timer
120 seconds for the suppress
timer
120 seconds
garbage-collect timer
for the