H3C S3610-28P Operation Manual page 838

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
II. Network diagram
AS 100
Source 1
Switch C
Device
Switch C
Switch F
Figure 7-5 Network diagram for configuration leveraging BGP routes
III. Configuration procedure
1) Configure the interface IP addresses and unicast routing protocol for each switch
Configure the IP address and subnet mask for each interface as per
Detailed configuration steps are omitted here.
Configure OSPF for interconnection between switches in each PIM-SM domain.
Ensure the network-layer interoperation among Switch A, Switch B and Switch C in
PIM-SM 1, the network-layer interoperation between Switch D and Switch E in PIM-SM
2, and the network-layer interoperation between Switch F and Switch G in PIM-SM 3,
and ensure the dynamic update of routing information between the switches in each
PIM-SM domain through a unicast routing protocol. Detailed configuration steps are
omitted here.
2) Enable IP multicast routing, and enable PIM-SM on each interface
# Enable IP multicast routing on Switch C, and enable PIM-SM on each interface.
<SwitchC> system-view
Receiver
Switch B Switch A
Vlan-int200
Vlan-int101
Loop0
PIM-SM 1
MSDP peers
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int200 10.110.2.1/24
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Vlan-int400 10.110.3.1/24
Vlan-int102 192.168.3.2/24
Loop0 3.3.3.3/32
AS 200
Loop0
Switch F
Vlan-int102
Vlan-int102
Vlan-int101
Switch D
Loop0
PIM-SM 2
Device
Switch D
7-18
Chapter 7 MSDP Configuration
Receiver
Switch G
Vlan-int400
PIM-SM 3
Receiver
Vlan-int300
Source 2
Switch E
Interface IP address
Vlan-int300 10.110.4.1/24
Vlan-int102 192.168.3.1/24
Vlan-int101 192.168.1.2/24
Loop0 2.2.2.2/32
Figure 7-5.