Configuring Trap Delivery - H3C S3610-28P Operation Manual

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches

1.3.3 Configuring Trap Delivery

I. Configuration prerequisites
Before configuring Trap delivery, you should configure the address of the network
management server which receives the Trap message. For detailed configuration
procedure, refer to the SNMP-RMON Configuration part of the manual.
II. Configuring Trap delivery
A trap message is generated no matter whether an NQA test succeeds or fails. You can
set a switch to control the delivery of the trap message to the network management
server.
Follow these steps to configure Trap:
Enter system view
Create an NQA test group
and enter its view
Enable trap debugging to
send a trap message to
the network management
server
Configure the minimum
number of probe failures
in an NQA test before a
test failure trap message
is sent
Configure the number of
consecutive probe failures
in an NQA test before a
trap message is sent to
indicate a probe failure
Note:
Currently, the device does not support Trap message delivery. Therefore, the above
configuration does not take effect actually.
To do...
system-view
nqa admin-name
operation-tag
send-trap { all |
{ probefailure |
testcomplete |
testfailure }* }
test-failtimes times
probe-failtimes times
Use the command...
1-30
Chapter 1 NQA Configuration
Remarks
—
Required
Optional
No trap message is sent
to the network
management server by
default.
Optional
1 by default.
Optional
1 by default.