H3C S3610-28P Operation Manual page 1313

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
2) Network diagram
Figure 1-5 Network diagram for the HTTP test
3) Configuration procedure
Note:
For the configuration of HTTP Server, refer to the Login Configuration part of the
manual.
Perform the following configurations on Switch A:
# Enable the NQA client, create an HTTP test group, and configure related test
parameters.
<SwitchA> system-view
[SwitchA] nqa-agent enable
[SwitchA] nqa admin http
[SwitchA-nqa-admin-http] test-type http
[SwitchA-nqa-admin-http] destination-ip 10.2.2.2
[SwitchA-nqa-admin-http] http-operation get
[SwitchA-nqa-admin-http] http-string /index.htm HTTP/1.0
# Enable the HTTP test.
[SwitchA-nqa-admin-http] test-enable
# View the test results with the display nqa results command.
[SwitchA-nqa-admin-http] display nqa results admin http
NQA entry(admin admin, tag http) test result:
Destination ip address: 10.2.2.2
Send operation times: 1
Min/Max/Average Round Trip Time: 15/15/15
Square-Sum of Round Trip Time: 225
Last succeeded test time: 2006-12-28 11:01:07.6
Extend result:
Packet lost in test: 0%
Failures due to Timeout: 0
Failures due to System Busy: 0
Receive response times: 1
1-12
Chapter 1 NQA Configuration