Mld Snooping Querier Configuration - H3C S3610-28P Operation Manual

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
# View the detailed information about MLD Snooping forwarding table entries in VLAN
100 on Switch A.
[SwitchA] display mld-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 2 port.
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
MAC group(s):
MAC group address:3333-0000-0101
As shown above, Ethernet 1/0/3 of Switch A has become a static router port.

3.8.3 MLD Snooping Querier Configuration

I. Network requirements
As shown in
attached to the multicast source (Source) through Ethernet 1/0/3. At least one
receiver is connected to Switch B and Switch C respectively.
MLDv1 is enabled on all the receivers. Switch A, Switch B, and Switch C run MLD
Snooping. Switch A acts as the MLD Snooping querier.
Eth1/0/1
Eth1/0/3
(::, FF1E::101):
Attribute: Host Port
Host port(s):total 1 port.
Eth1/0/2
Host port(s):total 1 port.
Eth1/0/2
Figure 2-5, in a Layer-2-only network environment, Switch C is
Chapter 3 MLD Snooping Configuration
(D) ( 00:01:30 )
(S)
(D) ( 00:03:23 )
3-26