H3C S3610-28P Operation Manual page 810

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim sm
[SwitchA-Vlan-interface102] quit
The configuration on Switch B and Switch C is similar to that on Switch A. The
configuration on Switch D and Switch E is also similar to that on Switch A except that it
is not necessary to enable IGMP on the corresponding interfaces on these two
switches.
3) Configure a C-BSR and a C-RP
# Configure the service scope of RP advertisements and the positions of the C-BSR
and C-RP on Switch E.
<SwitchE> system-view
[SwitchE] acl number 2005
[SwitchE-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchE-acl-basic-2005] quit
[SwitchE] pim
[SwitchE-pim] c-bsr vlan-interface 102
[SwitchE-pim] c-rp vlan-interface 102 group-policy 2005
[SwitchE-pim] quit
4) Verify the configuration
Carry out the display pim interface command to view the PIM configuration and
running status on each interface. For example:
# View the PIM configuration information on Switch A.
[SwitchA] display pim interface
Interface
Vlan100
Vlan101
Vlan102
To view the BSR election information and the locally configured C-RP information in
effect on a switch, use the display pim bsr-info command. For example:
# View the BSR information and the locally configured C-RP information in effect on
Switch A.
NbrCnt HelloInt DR-Pri
0 30 1
1 30 1
1 30 1
6-45
Chapter 6 PIM Configuration
DR-Address
10.110.1.1 (local)
192.168.1.2
192.168.9.2