H3C S3610-28P Operation Manual page 660

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Set a preference for the
matched routing protocol
Set a preferred value for
IPv6 BGP routes
Set a tag value for the
routes
Note:
The apply ipv6 next-hop commands do not apply to redistributed IPv6 routes
respectively.
6.4 Displaying and Maintaining the Routing Policy
Display IPv6 BGP AS
path ACL information
Display IPv6 BGP
community list information
Display IPv6 BGP
extended community list
information
Display IPv6 prefix list
statistics
Display routing policy
information
Clear IPv6 prefix statistics
6.5 Routing Policy Configuration Example
6.5.1 Applying Routing Policy When Redistributing IPv6 Routes
I. Network requirements
Enable RIPng on Switch A and Switch B.
To do...
apply preference
preference
apply preferred-value
preferred-value
apply tag value
To do...
display ip as-path
[ as-path-number ]
display ip community-list
[ basic-community-list-number |
adv-community-list-number ]
display ip extcommunity-list
[ ext-comm-list-number ]
display ip ipv6-prefix
[ ipv6-prefix-name ]
display route-policy
[ route-policy-name ]
reset ip ipv6-prefix
[ ipv6-prefix-name ]
Chapter 6 Routing Policy Configuration
Use the command...
Use the command...
6-9
Remarks
Optional
Not set by default
Optional
Not set by default
Optional
Not set by default
Remarks
Available in any
view