Chapter 3 Device Management; Device Management Overview; Configuring Device Management; Rebooting A Device - H3C S3610-28P Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches

Chapter 3 Device Management

When configuring device management, go to these sections for information you are
interested in:

Device Management Overview

Configuring Device Management

Displaying and Maintaining Device Management Configuration
Device Management Configuration Example
Note:
File names in this document comply with the following rules:
Path + file name (namely, a full file name): File on a specified path. A full file name
consists of 1 to 135 characters.
"File name" (namely, only a file name without a path): File on the current working
path. The file name without a path consists of 1 to 91 characters.
3.1 Device Management Overview
Through the device management function, you can view the current working state of a
device, configure running parameters, and perform daily device maintenance and
management.
Currently, the following device management functions are available:

Rebooting a Device

Specifying a Boot ROM File for the Next Device Boot
Upgrading Boot ROM
Configuring a Detection Interval
Clearing the 16-bit Interface Indexes Not Used in the Current System
3.2 Configuring Device Management
3.2.1 Rebooting a Device
When a fault occurs to a running device, you can remove the fault by rebooting the
device, depending on the actual situation. You can set a time at which the device can
automatically reboot. You can also set a delay so that the device can automatically
reboot in the delay.
3-1
Chapter 3 Device Management