H3C S3610-28P Operation Manual page 847

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
# View the brief MSDP peer information on Switch C.
[SwitchC] display msdp brief
MSDP Peer Brief Information
Configured
1
Peer's Address
2.2.2.2
# View the brief MSDP peer information on Router F.
[SwitchF] display msdp brief
MSDP Peer Brief Information
Configured
1
Peer's Address
1.1.1.1
7.7.3 Static RPF Peer Configuration Example
I. Network requirements
Two ISPs maintain their ASs, AS 100 and AS 200 respectively. OSPF is running
within each AS, and BGP is running between the two ASs.
PIM-SM 1 belongs to AS 100, while PIM-SM 2 and PIM-SM 3 belong to AS 200.
Each PIM-SM domain has zero or one multicast source and one or more receivers.
OSPF runs within each domain to provide unicast routes.
PIM-SM 2 and PIM-SM 3 are both PIM stub domains, and BGP is not required
between these two domains and PIM-SM 1. Instead, static RPF peers are
configured to avoid RPF check on SA messages.
The respective loopback interfaces of Switch C, Switch D and Switch F are
configured as the C-BSR and C-RP of the respective PIM-SM domains.
The static RPF peers of Switch C are Switch D and Switch F, while Switch C is the
only RPF peer of Switch D and Switch F. Any switch can receive the SA messages
sent by its static RPF peer(s) and permitted by the corresponding filtering policy.
Up Listen
1 0
State Up/Down time
Up 00:10:17
Up Listen
1 0
State Up/Down time
Up 00:10:18
7-27
Chapter 7 MSDP Configuration
Connect Shutdown
0 0
AS SA Count
? 0
Connect Shutdown
0 0
AS SA Count
? 0
Down
0
Reset Count
0
Down
0
Reset Count
0