Enabling Ssh Server - H3C S3610-28P Operation Manual

Operation Manual – SSH
H3C S3610&S5510 Series Ethernet Switches

1.2.2 Enabling SSH Server

Follow these steps to enable SSH server:
Enter system view
Enable the SSH server
function
1.2.3 Configuring the Protocol Support for an User Interface
After enabling the SSH server, you must configure the protocol support for the involved
interface(s). Note that the configuration takes effect at the next login.
Follow these steps to configure the protocols for the current user interface to support:
Enter system view
Enter single-user
interface view or
multi-user interface view
Set the login
authentication method to
scheme
Specify the protocols for
the user interfaces to
support
Caution:
For detailed information about the authentication-mode and protocol inbound
commands, refer to Login Commands.
If you configure a user interface to support SSH, be sure to configure the
corresponding authentication method with the authentication-mode scheme
command.
For a user interface configured to support SSH, you cannot configure the
authentication-mode password command and the authentication-mode none
command.
To do...
system-view
ssh server enable
To do...
system-view
user-interface
[ type-keyword ] number
[ ending-number ]
authentication-mode
scheme
[ command-authorization ]
protocol inbound { all | ssh
| telnet }
Use the command...
Use the command...
1-6
Chapter 1 SSH Configuration
Remarks
—
Required
Disabled by default
Remarks
—
Required
Required
By default, the
authentication mode is
password.
Optional
All protocols are
supported by default.