Configuring Cli Hotkeys - H3C S3610-28P Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches
Configure the banner to be
displayed when a user enters user
view
Configure the banner to be
displayed before login

1.1.5 Configuring CLI Hotkeys

Follow these steps to configure CLI hotkeys:
Enter system view
Configure CLI hotkeys
Display hotkeys
Note:
By default, the <Ctrl+G>, <Ctrl+L> and <Ctrl+O> hotkeys are configured with command
line and the <Ctrl+T> and <Ctrl+U> commands are NULL.
<Ctrl+G> corresponds to the display current-configuration command.
<Ctrl+L> corresponds to the display ip routing-table command.
<Ctrl+O> corresponds to the undo debugging all command.
Table 1-2 Hotkeys reserved by the system
Hotkey
<Ctrl+A>
<Ctrl+B>
<Ctrl+C>
<Ctrl+D>
<Ctrl+E>
<Ctrl+F>
To do...
To do...
system-view
hotkey { CTRL_G |
CTRL_L | CTRL_O |
CTRL_T | CTRL_U }
command
display hotkey
Moves the cursor to the beginning of the current line.
Moves the cursor one character to the left.
Stops performing a command.
Deletes the character at the current cursor position.
Moves the cursor to the end of the current line.
Moves the cursor one character to the right.
Use the command...
header shell text
header motd text
Use the command...
Function
1-7
Chapter 1 Basic Configurations
Remarks
Optional
Optional
Remarks
—
Optional
The <Ctrl+G>, <Ctrl+L>
and <Ctrl+O> hotkeys are
specified with command
lines by default.
Available in any view.
Refer to Table 1-2 for
hotkeys reserved by the
system.