H3C S3610-28P Operation Manual page 1423

Operation Manual – MCE
H3C S3610&S5510 Series Ethernet Switches
EBGP
Note:
This introduces the cooperation of routing protocols and MCE in brief. For details on
routing protocols, see the IPv4 Routing module of this manual.
I. Static routes
A CE can communicate with a site through static routes. As static routes configure for
traditional CEs take effect globally, address overlapping between multiple VPNs
remains
static-route-to-VPN-instance binding, which isolates the static routes of different VPNs.
II. RIP
A S3610&S5510 switch can bind RIP processes to VPN instances. With the same
binding configured on CE and site, private network routes of different VPNs can be
exchanged between CEs and sites through different RIP processes, thus isolating and
securing VPN routes.
III. OSPF
A S3610&S5510 switch can bind OSPF processes to VPN instances and isolate the
routes of different VPNs.
Note that:
For an OSPF process bound to a VPN instance, the router ID of the public network
configured in system view is invalid. So you need to specify the router ID when creating
an OSPF process.
An OSPF process can be bound to only one VPN instance, however, a VPN instance
can use multiple OSPF processes for private network route transmission. To make sure
routes can be advertised properly, you need to configure the same domain ID for all the
OSPF processes bound to a VPN instance.
a problem till the emergence
1-7
Chapter 1 MCE Overview
of MCE. MCE allows