System Maintaining And Debugging - H3C S3610-28P Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches
Figure 2-1 The relationship between the protocol and screen debugging switch
Note:
Displaying debugging information on the terminal is the most commonly used way to
output debugging information. You can also output debugging information to other
directions. For details, refer to Information Center Configuration.

2.2 System Maintaining and Debugging

2.2.1 System Maintaining
To do...
Check whether a
specified IP
address can be
reached
Use the command...
ping [ ip ] [ -a source-ip | -c count |
-f | -h ttl | -i interface-type
interface-number | -m interval | -n
| -p pad | -q | -r | -s packet-size | -t
timeout | -tos tos | -v |
-vpn-instance
vpn-instance-name ] *
remote-system
ping ipv6 [ -a source-ipv6 | -c
count | -m interval | -s packet-size
| -t timeout ] * remote-system [ -i
interface-type interface-number ]
2-3
Chapter 2 System Maintaining and Debugging
Optional
Used in IPv4 network
Available in any view
Optional
Used in IPv6 network
Available in any view
Remarks