H3C S3610-28P Operation Manual page 554

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches
On Switch B, configure route redistribution from IS-IS to OSPF and apply a routing
policy to set attributes of redistributed routes, setting the cost of route
172.17.1.0/24 to 100, tag of route 172.17.2.0/24 to 20.
II. Network diagram
Switch A
Figure 6-1 Network diagram for routing policy application to route redistribution
III. Configuration procedure
1) Specify IP addresses for interfaces (omitted).
2) Configure IS-IS
# Configure Switch C.
<SwitchC> system-view
[SwitchC] isis
[SwitchC-isis-1] is-level level-2
[SwitchC-isis-1] network-entity 10.0000.0000.0001.00
[SwitchC-isis-1] quit
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] isis enable
[SwitchC-Vlan-interface200] quit
[SwitchC] interface vlan-interface 201
[SwitchC-Vlan-interface201] isis enable
[SwitchC-Vlan-interface201] quit
[SwitchC] interface vlan-interface 202
[SwitchC-Vlan-interface202] isis enable
[SwitchC-Vlan-interface202] quit
[SwitchC] interface vlan-interface 203
[SwitchC-Vlan-interface203] isis enable
[SwitchC-Vlan-interface203] quit
# Configure Switch B.
<SwitchB> system-view
OSPF
Vlan-int100
192.168.1.2/24
Switch B
Vlan-int100
192.168.1.1/24
Chapter 6 Routing Policy Configuration
IS-IS
Vlan-int200
192.168.2.2/24
Vlan-int200
192.168.2.1/24
Switch C
6-11
Vlan-int201
172.17.1.1/24
Vlan-int202
172.17.2.1/24
Vlan-int203
172.17.3.1/24