Displaying And Maintaining The Tftp Client; Tftp Client Configuration Example - H3C S3610-28P Operation Manual

Operation Manual – File System Management
H3C S3610&S5510 Series Ethernet Switches

3.3 Displaying and Maintaining the TFTP Client

Display the configuration
of the TFTP client

3.4 TFTP Client Configuration Example

I. Network requirements
Use a PC as the TFTP server and your device as the TFTP client.
PC uses IP address 1.2.1.1./16 and a TFTP working directory has been defined
for the client.
On your device, VLAN-interface 1 is assigned an IP address 1.1.1.1/16. Make
sure that the port connected to PC belongs to the same VLAN.
TFTP a startup file from PC for upgrading and a configuration file config.cfg to PC
for backup.
II. Network diagram
Figure 3-2 Smooth upgrading using the TFTP client function
III. Configuration procedure
1) Configure PC (TFTP Server), the configuration procedure omitted.
On the PC, enable TFTP server
Configure a TFTP working directory
2) Configure the device (TFTP Client)
Caution:
If the free memory space of the device is not big enough, you should delete the existing
programs before downloading new ones.
# Enter system view.
<Sysname> system-view
To do...
display tftp client
configuration
Use the command...
3-4
Chapter 3 TFTP Configuration
Remarks
Available in any view