Configuring A Multicast Route Match Rule; Configuring Multicast Load Splitting - H3C S3610-28P Operation Manual

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
Follow these steps to configure a multicast static route:
To do...
Enter system view
Configure a
multicast static route
Caution:
When configuring a multicast static route, you cannot designate an RPF neighbor by
specifying an interface (by means of the interface-type interface-number command
argument combination) if the interface type of that router is Loopback or
VLAN-interface; instead, you can designate an RPF neighbor only by specifying an
address (rpf-nbr-address).

8.3.4 Configuring a Multicast Route Match Rule

If more than one route exists to the same subnet, a router chooses a route based on the
sequence of route configuration.
Follow these steps to configure a multicast route match rule:
Enter system view
Configure the device to
select a route based on
the longest match

8.3.5 Configuring Multicast Load Splitting

With the load splitting feature enabled, multicast traffic will be evenly distributed among
different routes.
system-view
ip rpf-route-static source-address { mask |
mask-length } [ protocol [ process-id ] ]
[ route-policy policy-name ]
{ rpf-nbr-address | interface-type
interface-number } [ preference
preference ] [ order order-number ]
To do...
system-view
multicast longest-match
Chapter 8 Multicast Routing and Forwarding
Use the command...
Use the command...
8-8
Configuration
Remarks
—
Required
No multicast
static route
configured by
default.
Remarks
—
Required
In order of routing table
entries by default