H3C S3610-28P Operation Manual page 1305

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
Set the test type to ICMP
Configure a destination
address for a test
Configure the size of test
packets sent
Configure a string of fill
characters of a test packet
Specify a VPN instance
Specify the IP address of
an interface as the source
IP address of an ICMP
test request packet
Configure common
optional parameters
Enable the NQA test
View the test results
II. Configuration example
1) Network requirements
Use the NQA ICMP function to test whether the NQA client (Switch A) can send packets
to the specified destination (Switch B) and test the roundtrip time of packets.
2) Network diagram
To do...
test-type icmp
destination-ip ip-address
datasize size
datafill text
vpninstance name
source-interface
interface-type
interface-number
Refer to
Optional Parameters for
NQA
test-enable
display nqa results
[ admin-name
operation-tag ]
Use the command...
Configuring
Tests.
1-4
Chapter 1 NQA Configuration
Remarks
Optional
ICMP by default.
Required
Optional
56 bytes by default.
Optional
The string of fill characters
of an ICMP packet is the
string corresponding with
the ASCII code 00 to 09
by default.
Optional
No VPN instance is
specified by default.
When there are multiple
VPNs, you need to use
this command to specify a
VPN instance for test.
Optional
The interface specified by
this command can only be
VLAN interface. In
addition, the interface
must be up. Otherwise,
the test will fail.
Optional
Required
Required
You can execute the
command in any view.