H3C S3610-28P Operation Manual page 809

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
II. Network diagram
Device
Switch A
Switch B
Switch C
Figure 6-11 Network diagram for PIM-SM domain configuration
III. Configuration procedure
1) Configure the interface IP addresses and unicast routing protocol for each switch
Configure the IP address and subnet mask for each interface as per
Detailed configuration steps are omitted here.
Configure the OSPF protocol for interoperation among the switches in the PIM-SM
domain. Ensure the network-layer interoperation among Switch A, Switch B, Switch C,
Switch D and Switch E in the PIM-SM domain and enable dynamic update of routing
information among the switches through a unicast routing protocol. Detailed
configuration steps are omitted here.
2) Enable IP multicast routing, and enable PIM-SM on each interface
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and
enable IGMPv2 on VLAN-interface 100, which connects Switch A to the stub network.
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Vlan-int102 192.168.9.1/24
Vlan-int200 10.110.2.1/24
Vlan-int103 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Vlan-int104 192.168.3.1/24
Device
Switch D
Switch E
6-44
Chapter 6 PIM Configuration
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int105 192.168.4.2/24
Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.2/24
Vlan-int102 192.168.9.2/24
Vlan-int105 192.168.4.1/24
Figure 6-11.