Enabling Msdp; Creating An Msdp Peer Connection - H3C S3610-28P Operation Manual

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches

7.3.2 Enabling MSDP

Follow these steps to enable MSDP:
Enter system view
Enable IP multicast
routing
Enable MSDP and enter
MSDP view

7.3.3 Creating an MSDP Peer Connection

An MSDP peering relationship is identified by an address pair, namely the address of
the local MSDP peer and that of the remote MSDP peer. An MSDP peer connection
must be created on both devices that are a pair of MSDP peers.
Follow these steps to create an MSDP peer connection:
Enter system view
Enter MSDP view
Create an MSDP peer
connection
Note:
If an interface of the router is shared by an MSDP peer and a BGP peer at the same
time, we recommend that you configuration the same IP address for the MSDP peer
and BGP peer.
7.3.4 Configuring a Static RPF Peer
Configuring static RPF peers avoids RPF check of SA messages.
To do...
system-view
multicast
routing-enable
msdp
To do...
system-view
msdp
peer peer-address
connect-interface
interface-type
interface-number
Use the command...
Use the command...
7-10
Chapter 7 MSDP Configuration
Remarks
—
Required
Disabled by default
Required
Disabled by default
Remarks
—
—
Required
No MSDP peer
connection created by
default