Configuring An Ipv6 Static Route; Displaying And Maintaining Ipv6 Static Routes - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
does not match any entry in the routing table, this default route will be used to forward
the packet.

1.2 Configuring an IPv6 Static Route

In small IPv6 networks, IPv6 static routes can be used to forward packets. In
comparison to dynamic routes, it helps to save network bandwidth.
1.2.1 Configuration prerequisites
Enabling IPv6 packet forwarding
Ensuring that the neighboring nodes are IPv6 reachable
1.2.2 Configuring an IPv6 Static Route
Follow these steps to configure an IPv6 static route:
To do...
Enter system view
Configure an IPv6
static route

1.3 Displaying and Maintaining IPv6 Static Routes

To do...
Display IPv6 static
route information
Remove all IPv6
static routes
Note:
Using the undo ipv6 route-static command can delete a single IPv6 static route, while
using the delete ipv6 static-routes all command deletes all IPv6 static routes
including the default route.
Use the commands...
System-view
ipv6 route-static ipv6-address
prefix-length [ interface-type
interface-number ]
nexthop-address [ preference
preference-value ]
Use the command...
display ipv6 routing-table protocol
static [ inactive | verbose ]
delete ipv6 static-routes all
1-2
Chapter 1 IPv6 Static Routing Configuration
Remarks
—
Required
The default preference of
IPv6 static routes is 60.
Available in any
view
Available in system
view
Remarks