H3C S3610-28P Operation Manual page 1316

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
View the recorded delay
jitter of UDP packet
transmission in the last
NQA jitter test
Note:
The number of probes made in a jitter test depends on the count command, while the
number of test packets sent in each probe depends on the jitter-packetnum
command.
II. Configuration example
1) Network requirements
Use the NQA jitter function to test the delay jitter of packet transmission between the
local port (Switch A) and the specified destination port (Switch B).
2) Network diagram
Figure 1-6 Network diagram for the jitter test
3) Configuration procedure
Configuration on Switch B
# Enable the NQA server and configure the listening IP address and port number.
<SwitchB> system-view
[SwitchB] nqa-server enable
[SwitchB] nqa-server udpecho 10.2.2.2 9000
Configuration on Switch A
# Enable the NQA client, create a jitter test group, and configure related test
parameters.
<SwitchA> system-view
[SwitchA] nqa-agent enable
[SwitchA] nqa admin jitter
[SwitchA-nqa-admin-jitter] test-type jitter
[SwitchA-nqa-admin-jitter] destination-ip 10.2.2.2
[SwitchA-nqa-admin-jitter] destination-port 9000
To do...
display nqa jitter
[ admin-name
operation-tag ]
Use the command...
1-15
Chapter 1 NQA Configuration
Remarks
Optional
Available in any view.