H3C S3610-28P Operation Manual page 1320

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
1.2.7 Configuring the TCP Test
Caution:
You are not recommended to perform an NQA TCP test on ports from 1 to 1023 (known
ports). Otherwise, the NQA test will fail or the corresponding services of this port will be
unavailable.
The TCP test is used to test the TCP connection between the client and the specified
server and the setup time for the connection.
The TCP test includes TCP-Public test and TCP-Private test.
For the TCP-Public test, a connection setup request is permanently initiated to
TCP port 7 of the destination address. No destination port needs to be configured
on the client, but TCP port 7 used for listening needs to be configured on the
server. Even if a port is configured on the client, the port does not take effect.
For the TCP-Private test, a connection setup request is initiated to the specified
port of the destination address.
I. Configuration procedure
1) Configure the NQA server
Follow these steps to configure the NQA server for the TCP test:
To do...
Enter system view
Enable the NQA
server
Configure the TCP
listening function on
the NQA server
Use the command...
system-view
nqa-server enable
nqa-server
tcpconnect ip-address
port-number
1-19
Chapter 1 NQA Configuration
Remarks
—
Required
Disabled by default
Required
The listening IP address and port
number must be the destination
IP address and port on the NQA
client. If the test type is
TCP-Public, the port number
must be set to 7.