H3C S3610-28P Operation Manual page 1324

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
Enter system view
Enable the NQA client
Create an NQA test group
and enter its view
Set the test type to UDP
Configure a destination
address for a test
Configure a destination
port
Configure the size of test
packets sent
Configure a string of fill
characters of a test packet
Configure common
optional parameters
Enable the NQA test
View the test results
II. Configuration example
1) Network requirements
Use the NQA UDP-Private function to test the setup time for the UDP connection
between the local port (Switch A) and the specified destination port (Switch B). The port
number used is 8000.
To do...
system-view
nqa-agent enable
nqa admin-name
operation-tag
test-type { udpprivate |
udppublic }
destination-ip ip-address
destination-port
port-number
datasize size
datafill text
Refer to
Optional Parameters for
NQA
test-enable
display nqa results
[ admin-name
operation-tag ]
Use the command...
Configuring
Tests.
1-23
Chapter 1 NQA Configuration
Remarks
—
Required
—
Required
Required
The destination address
must be the listening IP
address configured on the
NQA server.
If the test type is
UDP-Public, no port
needs to be configured. If
the test type is
UDP-Private, a port must
be configured and it must
be the listening port
configured on the NQA
server.
Optional
100 bytes by default.
Optional
The string of fill characters
of a UDP packet is the
string corresponding with
the ASCII code 00 to FF
by default.
Optional
Required
Required
Available in any view.