H3C S3610-28P Operation Manual page 1315

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
Enter system view
Enable the NQA server
Configure the UDP
listening function on
the NQA server
2) Configure the NQA client
Follow these steps to configure the NQA client for a jitter test:
Enter system view
Enable the NQA client
Create an NQA test group
and enter its view
Set the test type to jitter
Configure a destination
address for a test
Configure a destination
port
Configure the number of
jitter test packets sent in a
probe
Configure the interval for
sending jitter test packets
Configure common
optional parameters
Enable the NQA test
View the test results
To do... Use the command...
system-view
nqa-server enable
nqa-server udpecho
ip-address port-number
To do...
system-view
nqa-agent enable
nqa admin-name
operation-tag
test-type jitter
destination-ip ip-address
destination-port
port-number
jitter-packetnum number
jitter-interval interval
Refer to
Optional Parameters for
NQA
test-enable
display nqa results
[ admin-name
operation-tag ]
—
Required
Disabled by default
Required
The listening IP address and
port number must be the
destination IP address and port
on the NQA client.
Use the command...
Configuring
Tests.
1-14
Chapter 1 NQA Configuration
Remarks
Remarks
—
Required
—
Required
Required
The destination address is
the listening IP address
on the NQA server.
Required
The destination port is the
listening port on the NQA
server.
Optional
10 by default.
Optional
20 ms by default.
Optional
Required
Required
Available in any view.