Configuring Ripng Route Redistribution; Tuning And Optimizing The Ripng Network - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Follow these steps to configure a RIPng priority:
Enter system view
Enter RIPng view
Configure a RIPng priority

2.3.6 Configuring RIPng Route Redistribution

Follow these steps to configure RIPng route redistribution:
Enter system view
Enter RIPng view
Configure a default
routing metric for
redistributed routes
Redistribute routes from
another routing protocol

2.4 Tuning and Optimizing the RIPng Network

This section describes how to tune and optimize the performance of the RIPng network
as well as applications under special network environments. Before tuning and
optimizing the RIPng network, complete the following tasks:
Configure a network layer address for each interface
Configure the basic RIPng functions
This section covers the following topics:
Configuring RIPng Timers
Configuring Split Horizon and Poison Reverse
Configuring Zero Field Check on RIPng Packets
Configuring the Maximum Number of Equal Cost Routes for Load Balancing
To do...
system-view
ripng [ process-id ]
preference
[ route-policy
route-policy-name ]
preference
To do...
system-view
ripng [ process-id ]
default cost cost
import-route protocol
[ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy
route-policy-name ] *
Chapter 2 IPv6 RIPng Configuration
Use the command...
Use the command...
2-7
Remarks
—
—
Optional
By default, the RIPng
priority is 100.
Remarks
––
––
Optional
By default, the default
metric of redistributed
routes is 0.
Required
No route redistribution is
configured by default.