H3C S3610-28P Operation Manual page 1394

Operation Manual – SSH
H3C S3610&S5510 Series Ethernet Switches
[Switch] ssh server enable
# Configure an IP address for VLAN-interface 1, which the SSH client will use as the
destination for SSH connection.
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.1.40 255.255.255.0
[Switch-Vlan-interface1] quit
# Set the authentication mode for the user interface to AAA.
[Switch] user-interface vty 0 4
[Switch-ui-vty0-4] authentication-mode scheme
# Enable the user interface to support SSH.
[Switch-ui-vty0-4] protocol inbound ssh
# Set the user command privilege level to 3.
[Switch-ui-vty0-4] user privilege level 3
[Switch-ui-vty0-4] quit
Note:
Before performing the following tasks, you must generate an RSA key pair (using the
client software) on the client, save the public key in a file named key.pub, and then
upload the file to the SSH server through FTP or TFTP. For details, refer to Configuring
the SSH Client.
# Import the client's public key from file key.pub.
[Switch] public-key peer Switch001 import sshkey key.pub
# Specify the authentication type for user client002 as publickey, and assign the public
key Switch001 for the user.
[Switch]
publickey assign publickey Switch001
2) Configure the SSH client
# Generate an RSA key pair.
Run PuTTYGen.exe, choose SSH-2 RSA and click Generate.
ssh user client002 service-type stelnet
1-19
Chapter 1 SSH Configuration
authentication-type