Connecting The Camera For The Nanolockspray Source Or Ionkey Source; Installing The Camera Driver Software - Waters Xevo G2-XS QTof Overview And Maintenance Manual

Connecting the camera for the NanoLockSpray source or
ionKey source
The camera for both the NanoLockSpray™ and ionKey™ source is connected
to the workstation PC by means of a USB converter.
To connect the camera to the workstation:
1. Connect the coaxial cable between the video output connector on the
instrument's rear panel and the interface box.
2. Connect the USB cable between the interface box and any free USB
socket on the workstation.

Installing the camera driver software

The workstation is supplied with camera-driver software pre-installed.
Nevertheless, if you reinstall or reconfigure the workstation, you must
reinstall the software. If this is the case, then Windows
New Hardware Wizard when you connect the USB converter.
Installing the camera driver software:
1. In the Found New Hardware Wizard dialog box, prevent Windows from
connecting to Windows Update by selecting "No, not at this time", and
click Next.
2. Click Install from a list or specific location (Advanced), and click Next.
3. Select "Search for the best driver in these locations".

Connecting the camera for the NanoLockSpray source or ionKey source

Video output connector
Instrument LAN
External Connections 1
10 9 8 7 6 5 4 3 2 1
Service Bus
EPC Com Port
OUT - IN - IN
EPC Parallel Port
External Connections 2
10 9 8 7 6 5 4 3 2 1
Video Output
OUT - OUT OUT OUT
10 1
External Connections 1
10 1
External Connections 2
System Activity
USB converter
interface box
®
April 2, 2015, 715004496 Rev. B
Workstation
presents the Found
301