Configuring For Apci Mode; Installing The Ionsabre Ii Probe - Waters Xevo G2-XS QTof Overview And Maintenance Manual

3 Configuring the LockSpray Source

Configuring for APCI mode

To operate in APCI mode, you must fit the IonSABRE II probe to the
LockSpray source enclosure.
For more information on using APCI mode, see the Xevo G2-XS QTof system
online Help.

Installing the IonSABRE II probe

Required materials
• Chemical-resistant, powder-free gloves
• Sharp knife or PEEK tubing cutter
To install the IonSABRE II probe:
Warning:
prepared for working on the source before commencing this procedure.
62 April 2, 2015, 715004496 Rev. B
To avoid personal contamination with biologically
Warning:
hazardous, toxic, or corrosive materials, and to avoid
spreading contamination to uncontaminated surfaces, wear
clean, chemical-resistant, powder-free gloves when working
with the LC system connections, IonSABRE II probe, and
source.
To avoid electric shock, ensure that the instrument is