Installing The Camera In The Ionkey Source; Removing An Ionkey Source - Waters Xevo TQ-S Operator's, Overview And Maintenance Manual

Installing the camera in the ionKey source

To install the camera in the ionKey source:
1. Connect the camera cable from the video output connector on the mass
spectrometer's rear panel to the video-to-USB converter box.
2. Connect the video-to-USB converter box to a USB port on the mass
spectrometer's workstation.
3. On the Tune page, click Camera Viewer
4. In Device settings dialog box, specify the parameter settings according
to the following table, and then click OK.
After you install the camera software, when you select the ionKey
Tip:
camera viewer for the first time, the device settings dialog box opens. To
subsequently open the device settings dialog box, in the camera viewer,
click View > Camera Options.
Device settings for the camera:
Parameter
Video norm
Video format
Frame rate (FPS)
Input channel

Removing an ionKey source

You can remove the ionKey source, and replace it with a conventional
interface.
The ionKey/MS System Guide.
See also:
Required materials
• Chemical-resistant, powder-free gloves
.
Setting
PAL_B
Y800 (768 x 576)
25
00 Video: Composite
February 28, 2014, 715002212 Rev. C
ionKey source
89