Waters Xevo G2-XS QTof Overview And Maintenance Manual page 168

6 Maintenance Procedures
Cutout
5. With the StepWave removal and insertion tool's cutout uppermost,
insert the StepWave removal and insertion tool's pins into the ion block
support screw holes above and below the aperture in the pumping block
assembly.
Notice:
assembly to the adaptor housing, handle only the brown, PEEK,
ion-guide cap.
6. Inserting your thumbs through the slots in the StepWave removal and
insertion tool, firmly push the StepWave ion guide assembly into the
pumping block assembly.
You will detect some resistance to motion when the StepWave
Tip:
assembly encounters the seal inside the instrument; continue pushing
until you detect further resistance.
7. Remove the StepWave removal and insertion tool.
168 April 2, 2015, 715004496 Rev. B
StepWave assembly
removal and insertion tool
To avoid damage when fitting the StepWave ion guide
StepWave assembly
Pins