3 Configuring the LockSpray Source
3.
Tighten the probe locking ring to secure the probe in place.
An automatic pressure test is performed when the probe is correctly
Tip:
seated in position.
IonSABRE II probe mounted on the source enclosure:
Vernier probe
adjuster
Source window
4.
Open the access door to the fluidics valves (see the figure on
Warning:
to connect the diverter valve to the IonSABRE II probe; use the
PEEK tubing supplied with the instrument.
64
April 2, 2015, 715004496 Rev. B
To avoid electric shock, do not use stainless steel tubing
IonSABRE II probe
Source enclosure
release
TP03128
page
28).