5.
Route the loose (unfitted) end of the fluid line through the fluid-line
aperture and out of the source enclosure.
You can open and close the aperture by pulling and releasing the
Tip:
captive aperture assembly as shown below.
Fluid-line aperture:
Fluid-line aperture
6.
Fit a ferrule, locking ring, and compression fitting to the loose end of the
fluid line.
7.
Attach the fluid line to the appropriate port on the ACQUITY UPLC
M-Class system, or to the onboard IntelliStart Fluidics on the mass
spectrometer (see
Replacing the fluid lines of the ionKey source
"Installing the ionKey source" on page
April 2, 2015, 715004496 Rev. B
Aperture closed
Aperture open
78).
253