Waters Xevo G2-XS QTof Overview And Maintenance Manual page 94

6 Maintenance Procedures
Maintenance schedule:
Procedure
Replace the IonSABRE II
probe capillary.
Replace the LockSpray probe
capillary.
Replace the NanoLockSpray
reference probe capillary.
Clean or replace the corona
pin (APCI and ESCi modes).
Replace the IonSABRE II
probe heater.
Replace the ion block heater
cartridge.
Replace the source assembly
seals.
Replace the mass
spectrometer air filters.
Replace the IntelliStart
Fluidics tubing.
Replace an ionKey source
fluid line.
Clean the ionKey source
surface, fluid connectors, or
electronic connectors.
94 April 2, 2015, 715004496 Rev. B
Frequency
When sensitivity
decreases to
unacceptable levels or
sample flow is
inconsistent.
Annually.
Annually.
When the corona pin is
corroded or blackened,
or the sensitivity
decreases to
unacceptable levels.
If the heater fails to
heat the probe.
If the heater fails to
heat the ion block.
Annually.
Annually.
In the event of
blockage in the tubing
connections between
the IntelliStart
Fluidics system
components.
As required or during
periodic maintenance.
As required or during
periodic maintenance.
For information...
See page 184.
See page 191.
See page 197.
See page 207.
See page 208.
See page 211.
See page 215.
See page 219.
See page 223.
See page 249.
See page 254.