Connecting To A Cart's Electricity Source - Waters ACQUITY UPLC M-Class System Manual

Recommendation:
optimum, long-term, input-voltage stability. Contact Waters to ensure the correct selection and
size.
To connect to a wall electricity source:
1. Connect the female end of the power cord to the receptacle on the rear panel of the
module.
2. Connect the male end of the power cord to a suitable grounded wall outlet.
C.4.2 Connecting to a cart's electricity source
If your system includes an optional cart, follow this procedure to connect each module to a power
source.
Warning:
• Use SVT-type power cords in the United States and HAR-type power cords, or
better, in Europe. For requirements elsewhere, contact your local Waters distributor.
• Inspect the power cords for damage and replace them if necessary.
• Power-off and unplug each module before performing any maintenance operation on
it.
• Connect each module to a common ground.
Recommendation:
long-term input-voltage stability.
To connect to a cart's electricity source:
1. Connect the female end of the cart's electrical cables (included in the startup kit) to the
receptacle on the rear panel of each system module.
2. Connect the hooded, male end of the cart's electrical cables to the power strips on its back.
3. Connect each power strip's cable to a wall outlet operating on its own circuit.
Use a line conditioner and uninterruptible power supply (UPS) for
To avoid electric shock, observe these precautions:
Use a line conditioner and uninterruptible power supply (UPS) for optimum
November 26, 2019, 715003588 Revision C
Page 99