Configuring For Esci Mode; Optimizing The Esi Probe For Esci Operation - Waters Xevo G2-XS QTof Overview And Maintenance Manual

3 Configuring the LockSpray Source

Configuring for ESCi mode

To operate the instrument in ESCi mode, you must fit an ESI probe and
corona pin to the LockSpray source enclosure, (see
page 103).
The system, with the ESI probe installed and corona discharge pin fitted, can
alternate between ESI and ESCi modes, facilitating data acquisition in ESI
and ESCi modes in parallel. For more information on using dual ESI and
ESCi modes, see the Xevo G2-XS QTof system online Help.

Optimizing the ESI probe for ESCi operation

See the mass spectrometer's online Help for instructions explaining how to
optimize the ESI probe for ESCi operation.
66 April 2, 2015, 715004496 Rev. B
page 33, page 61, and