Figure 116: Removing a MIC
Figure 117: Removing a Dual-Wide MIC
Ejectors
MIC handles
SEE ALSO
MX240 Modular Interface Card (MIC) Description | 139
Troubleshooting the MX240 MICs | 433
MX240 MIC Serial Number Label | 449
Installing an MX240 MIC
To install a MIC (see
Figure 119 on page
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. If you have used a dual-wide MIC and are now replacing it with two "single" MICs, install the septum
(see
Figure 118 on page
a. Place the MPC on a flat surface (if necessary, remove the MPC from the router as described in
"Removing an MX240 MPC" on page
b. Position the septum in the center of the MPC so that it lines up with holes labeled S on the top of
the MPC.
c. Insert a screw into each of the two holes labeled S, and then tighten completely.
341):
339):
347).
338