Installing An Mx2020 Mic - Juniper MX2020 Hardware Manual

Figure 241: Removing a Single-Wide MIC
0
SEE ALSO
Prevention of Electrostatic Discharge Damage | 770

Installing an MX2020 MIC | 555

Installing an MX2020 Dual-Wide MIC | 558
Installing an MX2020 MIC
To install a MIC (see Figure 243 on page
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. If you have used a dual-wide MIC and are now replacing it with two single-wide MICs, install the septum
(see Figure 242 on page 556
a. Place the MPC on a flat surface (if necessary, remove the MPC from the ADC as described in
"Removing an MX2020 MPC from the Adapter Card" on page
b. Position the septum in the center of the MPC so that it lines up with holes labeled S on the top of
the MPC.
c. Insert a screw into each of the two holes labeled S, and then tighten them completely.
19
558):
):
539.
555