Edge-Core ECS4810-12M Layer 2 Management Manual page 53

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

Figure 68: Creating Static VLANs

Figure 69: Modifying Settings for Static VLANs

Figure 70: Showing Static VLANs

Figure 71: Configuring Static Members by VLAN Index

Figure 72: Configuring Static VLAN Members by Interface

Figure 73: Configuring Static VLAN Members by Interface Range

Figure 74: Configuring Global Status of GVRP

Figure 75: Configuring GVRP for an Interface

Figure 76: Showing Dynamic VLANs Registered on the Switch

Figure 77: Showing the Members of a Dynamic VLAN

Figure 78: Showing VLAN Statistics

Figure 79: QinQ Operational Concept

Figure 80: Enabling QinQ Tunneling

Figure 81: Configuring CVLAN to SPVLAN Mapping Entries

Figure 82: Showing CVLAN to SPVLAN Mapping Entries

Figure 83: Adding an Interface to a QinQ Tunnel

Figure 84: Configuring Protocol VLANs

Figure 85: Displaying Protocol VLANs

Figure 86: Assigning Interfaces to Protocol VLANs

Figure 87: Showing the Interface to Protocol Group Mapping

Figure 88: Configuring IP Subnet VLANs

Figure 89: Showing IP Subnet VLANs

Figure 90: Configuring MAC-Based VLANs

Figure 91: Showing MAC-Based VLANs

Figure 92: Configuring VLAN Mirroring

Figure 93: Showing the VLANs to Mirror

Figure 94: Configuring VLAN Translation

Figure 95: Configuring VLAN Translation

Figure 96: Showing the Entries for VLAN Translation

Figure 97: Configuring Static MAC Addresses

Figure 98: Displaying Static MAC Addresses

Figure 99: Setting the Address Aging Time

Figure 100: Displaying the Dynamic MAC Address Table

Figure 101: Clearing Entries in the Dynamic MAC Address Table

Figure 102: Mirroring Packets Based on the Source MAC Address

Figure 103: Showing the Source MAC Addresses to Mirror

Chapters

Table of Contents