Configuring Telnet Settings - Edge-Core ECS4810-12M Layer 2 Management Manual

C T
ONFIGURING ELNET
W I
EB NTERFACE
To configure parameters for the console port:
Click System, then Console.
1.
Specify the connection parameters as required.
2.
Click Apply
3.
Figure 16: Console Port Settings
S
ETTINGS
Use the System > Telnet menu to configure parameters for accessing the
CLI over a Telnet connection. You can access the onboard configuration
program over the network using Telnet (i.e., a virtual terminal).
Management access via Telnet can be enabled/disabled and other
parameters set, including the TCP port number, time outs, and a password.
Note that the password is only configurable through the CLI.) These
parameters can be configured via the web or CLI interface.
CLI R
EFERENCES
"Line" on page 715
◆
"Telnet Server" on page 825
◆
P
ARAMETERS
The following parameters are displayed:
Telnet Status – Enables or disables Telnet access to the switch.
◆
(Default: Enabled)
TCP Port – Sets the TCP port number for Telnet on the switch.
◆
(Range: 1-65535; Default: 23)
Max Sessions – Sets the maximum number of Telnet sessions that can
◆
simultaneously connect to this system. (Range: 0-8; Default: 8)
– 141 –
| Basic Management Tasks
C 4
HAPTER

Configuring Telnet Settings