Resetting The System - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

ESETTING THE

Use the System > Reset menu to restart the switch immediately, at a

specified time, after a specified delay, or at a periodic interval.

"reload (Privileged Exec)" on page 680

"reload (Global Configuration)" on page 676

"show reload" on page 681

This command resets the entire system.

When the system is restarted, it will always run the Power-On Self-Test.

It will also retain all configuration information stored in non-volatile

memory by the

copy running-config startup-config

"copy" on page

The following parameters are displayed:

System Reload Information

Reload Settings – Displays information on the next scheduled reload

and selected reload mode as shown in the following example:

The switch will be rebooted at March 9 12:00:00 2012. Remaining

Time: 0 days, 2 hours, 46 minutes, 5 seconds.

Reloading switch regularly time: 12:00 everyday."

– Refreshes reload information. Changes made through the

console or to system time may need to be refreshed to display the

current settings.

– Cancels the current settings shown in this field.

System Reload Configuration

Reset Mode – Restarts the switch immediately or at the specified

Immediately – Restarts the system immediately.

In – Specifies an interval after which to reload the switch.

(The specified time must be equal to or less than 24 days.)

hours – The number of hours, combined with the minutes,

before the switch resets. (Range: 0-576)

minutes – The number of minutes, combined with the hours,

before the switch resets. (Range: 0-59)

| Basic Management Tasks

Resetting the System

command (see

Table of Contents