Assigning Static Multicast Groups To Interfaces; Figure 15-10 Mvr Group Member Configuration - Edge-Core ES3528-WDM Management Manual

Assigning Static Multicast Groups to Interfaces

For multicast streams that will run for a long term and be associated with a stable set
of hosts, you can statically bind the multicast group to the participating interfaces.
Command Usage
• Any multicast groups that use the MVR VLAN must be statically assigned to it
under the MVR Configuration menu (see "Configuring Global MVR Settings" on
page 15-10).
• The IP address range from 224.0.0.0 to 239.255.255.255 is used for multicast
streams. MVR group addresses cannot fall within the reserved IP multicast
address range of 224.0.0.x.
Command Attributes
• Interface – Indicates a port or trunk.
• Member – Shows the IP addresses for MVR multicast groups which have been
statically assigned to the selected interface.
• Non-Member – Shows the IP addresses for all MVR multicast groups which have
not been statically assigned to the selected interface.
Web – Click MVR, Group Member Configuration. Select a port or trunk from the
"Interface" field, and click Query to display the assigned multicast groups. Select a
multicast address from the displayed lists, and click the Add or Remove button to
modify the Member list.
CLI – This example statically assigns a multicast group to a receiver port.
Console(config)#interface ethernet 1/2
Console(config-if)#mvr group 228.1.23.1
Console(config-if)#

Figure 15-10 MVR Group Member Configuration

Multicast VLAN Registration
15
24-1
33-13
15-15