Edge-Core ECS4810-12M Layer 2 Management Manual page 115

Table 6: Switch Main Menu (Continued)
Menu
Configure MA
Add
Configure Details
Show
Configure MEP
Add
Show
Configure Remote MEP
Add
Show
Transmit Link Trace
Transmit Loopback
Transmit Delay Measure
Show Information
Show Local MEP
Show Local MEP Details
Show Local MIP
Show Remote MEP
Show Remote MEP Details
Show Link Trace Cache
Show Fault Notification Generator
Show Continuity Check Error
OAM
Interface
Counters
Event Log
Remote Interface
Remote Loopback
Description
Configure Maintenance Associations
Defines a unique CFM service instance, identified by its parent MD,
the MA index, the VLAN assigned to the MA, and the MIP creation
method
Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal
parameters
Shows list of configured maintenance associations
Configures Maintenance End Points
Configures MEPs at the domain boundary to provide management
access for each maintenance association
Shows list of configured maintenance end points
Configures Remote Maintenance End Points
Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages
Shows list of configured remote maintenance end points
Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node
Sends loopback messages to isolate connectivity faults by
requesting a target node to echo the message back to the source
Sends periodic delay-measure requests to a specified MEP within a
maintenance association
Shows the MEPs configured on this device
Displays detailed CFM information about a specified local MEP in
the continuity check database
Shows the MIPs on this device discovered by the CFM protocol
Shows MEPs located on other devices which have been discovered
through continuity check messages, or statically configured in the
MEP database
Displays detailed CFM information about a specified remote MEP in
the continuity check database
Shows information about link trace operations launched from this
device
Displays configuration settings for the fault notification generator
Displays CFM continuity check errors logged on this device
Operation, Administration, and Maintenance
Enables OAM on specified port, sets the mode to active or passive,
and enables the reporting of critical events or errored frame events
Displays statistics on OAM PDUs
Displays the log for recorded link events
Displays information about attached OAM-enabled devices
Performs a loopback test on the specified port
– 115 –
| Using the Web Interface
C 3
HAPTER
Navigating the Web Browser Interface
Page
525
525
525
525
530
530
530
531
531
531
533
535
537
539
540
541
542
543
545
547
548
550
550
552
553
554
555