Edge-Core ECS4810-12M Layer 2 Management Manual page 9

◆ Added the parameter "hardware counters" to the command
access-list" on page
◆ Added the commands
page 959.
◆ Added the command
◆ Updated description of commands
page 968, "transceiver-threshold rx-power" on page
threshold temperature" on page
on page 971, and "transceiver-threshold voltage" on page
◆ Added the command
page 974.
◆ Added the command
◆ Added "access-list" parameter, and information about how to use this
parameter in the Command Usage section, for the command
monitor" on page 993.
◆ Added parameters "brief" and "stp-enabled-only" for the command
"show spanning-tree" on page
◆ Updated syntax for the command
◆ Added commands for ERPS version 2, including
page 1074, "non-revertive" on page
page 1082, "raps-without-vc" on page
page 1085, "version" on page
forced-switch" on page
◆ Added the command
◆ Added "port-channel" parameter for the command
page 1084
◆ Added the command
◆ Added "statistics" parameter for the command
page 1093.
◆ Updated syntax for
page 1117.
◆ Added the section "Configuring VLAN Translation" on page
◆ Added "priority" parameter to the command
protocol-group (Configuring Interfaces)" on page
◆ Added "ipv6 dscp" parameter to the command
– 9 –
947.
"discard" on page 953
"transceiver-monitor" on page
"transceiver-threshold current" on
970, "transceiver-threshold tx-power"
"show interfaces transceiver-threshold" on
"lacp timeout" on page
1064.
"erps domain" on page
1077,
1082,
1087, "erps clear" on page
1089, and "erps manual-switch" on page
"non-erps-dev-protect" on page
"clear erps statistics" on page
"switchport dot1q-tunnel service match cvid" on
A T G
BOUT HIS
"show
and "show discard" on
967.
969, "transceiver-
972.
987.
"port
1069.
"mep-monitor" on
"raps-def-mac" on
"rpl neighbor" on
1089, "erps
1091.
1076.
"ring-port" on
1088.
"show erps" on
1125.
"protocol-vlan
1129.
"match" on page 1160.
UIDE