C H A P T E R 16 Disaster Recovery Procedures - Cisco BTS 10200 Troubleshooting Manual

Chapter 16 Disaster Recovery Procedures
Flash Archive Restore
Cisco recommends running this procedure during maintenance window or when traffic is low.
Note
Connect to the console of the restored unit.
Step 1
Load the bootable Solaris-10 CD into the compact disk–read only media (CD-ROM) drive.
Step 2
At the ok> prompt, type: boot cdrom
Step 3
Enter 0 for English.
Step 4
Enter 14 for Other.
Step 5
Enter vt100 for terminal type.
Step 6
Press Esc-2 to continue.
Step 7
Press Esc-2 again to continue.
Step 8
Step 9 Press Esc-2 to continue, use default setting (Mark X on Yes for Networked).
Step 10 Choose primary interface then Esc-2 to continue.
Step 11 Press Esc-2 to continue, use default setting (Mark X on No for Use Dynamic Host Configuration
Protocol (DHCP)).
Step 12 Enter <hostname>, then press Esc-2 to continue.
Step 13 Enter <IP address>; then press Esc-2 to continue.
Step 14 Press Esc-2 to continue, use default setting (Mark X on Yes for System part of a subnet).
Enter <Netmask>; then press Esc-2 to continue.
Step 15
Press Esc-2 to continue, use default setting (Mark X on No for Enable IPv6).
Step 16
Confirm the network information and press Esc-2 to continue.
Step 17
Press Esc-2 to continue, use default setting (Mark X on No for Configure Kerberos Security).
Step 18
Press Esc-2 to continue.
Step 19
Mark X on None for Name service. Press Esc-2 to continue.
Step 20
Confirm the information and press Esc-2 to continue.
Step 21
Choose Continents and Oceans then Esc-2.
Step 22
Choose Countries and Regions then Press Esc-2.
Step 23
Mark X on Timezone. Press Esc-2 to continue.
Step 24
Step 25 Set date and time. Press Esc-2 to continue.
Step 26 Confirm the information and press Esc-2 to continue.
Step 27 Choose F4 for Flash installation, Esc-4.
Step 28 Choose Manual reboot, then Press Esc-2.
Mark x on NFS for NFS Flash Archive Retrieval Method then Press Esc-2.
Step 29
Provide the location of the archive, as shown in the following example and Press Esc-2:
Step 30
10.89.224.1:/archive/prica18.archive
Press Esc-2 to continue.
OL-8723-19
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Disaster Recovery From Flash Archive
16-3