Query Verification Tool And Translation Verification Tool - Cisco BTS 10200 Troubleshooting Manual

Hide thumbs Also See for BTS 10200:

Table of Contents

Diagnostic Tests

COPs example:

10.0.0.1 is a cable modem termination system (CMTS) and is configured as an aggregation identification

(AGGR-ID) in the BTS 10200. The goal is to monitor all Common Open Policy Service Protocol (COPS)

messaging to and from the CMTS.

Packets can be redirected to a file (not readable by Ethereal) at follows:

# snoop -d qfe0 -x 42 host 10.0.0.1 and port 2427 and udp > mycapt.cap

Stop the snoop processes.

# pkill snoop

# pgrep snoop (should not report any process ids)

Query Verification Tool and Translation Verification Tool

This section describes the Query Verification Tool (QVT) and the Translation Verification Tool (TVT)

and is organized into the following sub-sections:

Tool Requirements

The following requirements are supported in the QVT and TVT:

Issue the following command:

# snoop -d qfe0 -o cops.cap host 10.0.0.1 and port 2126 and tcp

Use Control-C to stop the packet capture. Open the file in Ethereal and inspect.

Tool Requirements, page 15-19

Query Verification Tool, page 15-20

Translation Verification Tool, page 15-27

Using Query Verification Tool and Translation Verification Tool Together, page 15-30

TVT—Provide a tool to find, diagnose, and trace call flow path decisions.

Query Local Routing Number (QLRN) Tool—Provide the ability to enter a ten digit directory

number and launch a query to the service control point (SCP) as though it was a called number from

the signal switching point (SSP).

Query Tool E800VER Command—Send a database query to the SCP as if it was an 800 called

number from the SSP without initiating a call.

Query Tool CNAMDVER and TESTSS CNAMD Commands—Provide the ability to query the SCP

database for the calling name delivery (CNAM) display and privacy status associated with the name

without initiating a call.

Query Verification Tool and Translation Verification Tool

Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x

Table of Contents