Cisco BTS 10200 Troubleshooting Manual page 701

Chapter 15 Diagnostic Tests
Command Line Tokens
The following table lists the command line tokens associated with this command and the valid values
and purpose of each:
Table 15-6 Command Line Tokens Associated with Measurement Report Summaries
Command Line Token
start-time
end-time
interval
sum
output
output-type
display
OL-8723-19
Description
A time stamp value in the format of YYYY-MM-DD HH:MM:SS. This value indicates the starting
interval time to search for within the EMS database.
This is an optional token. When omitted, it results in the display of the last collected interval.
A time stamp value in the format of YYYY-MM-DD HH:MM:SS. This value indicates the stopping
interval time to search for within the EMS database.
This is an optional token. When omitted, it results in the display of the last collected interval.
This token is optional and is used to specify that a report be generated that contains counter
information for the interval currently under collection (CURRENT) or all of the collected intervals
persisted on disk (ALL).
If this token is used on the command line, it overrides start-time and end-time tokens that are
specified. If entered, the corresponding call-agent-id or feature-server-id must be specified.
There is no default value for this token. If this token and the start-time token are not entered by the
user, the last collected interval is reported.
This token indicates whether the resulting report request contains the individual interval reports
(N) or a summation of all interval reports into one composite report (Y).
The default value for this token is N. This token is not allowed in combination with the trunk group
category.
This token indicates the name of the file to be created and the location where the resulting
measurement data is placed. The file name is pre-pended with the string "Tm_" and placed in the
/opt/ems/report directory on the active EMS.
The format of the output file, which can be in comma-separated value (csv) or XML format.
Allows you to specify the columns of data to present in the resulting report. Only those columns
specified are shown in the report. If you enter a value of "%", then a list of all possible column
values are displayed, but the report itself is not created.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Enhanced Traffic Measurement
15-75