Maintenance (31) - Cisco BTS 10200 Troubleshooting Manual

Maintenance Events and Alarms

MAINTENANCE (31)

MAINTENANCE (31) is not used.
MAINTENANCE (32)
For additional information, refer to the
(32)" section on page
DESCRIPTION Process Manager: Sending Go Active to Process (PMG: Sending Go Active to Process)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS Process Name–STRING [40]
Process Group–ONE_BYTE
PRIMARY Process is being notified to switch to the active state as the system is switching over from the standby
CAUSE state to the active state.
PRIMARY No action is necessary.
ACTION
MAINTENANCE (33)
For additional information, refer to the
Process—Maintenance (33)" section on page
DESCRIPTION Process Manager: Sending Go Standby to Process (PMG: Sending Go Standby to Process)
SEVERITY INFO
THRESHOLD 100
THROTTLE 0
DATAWORDS Process Name–STRING [40]
Process Group–ONE_BYTE
PRIMARY The process is being notified to exit gracefully as the system is switching over to the standby state, or
CAUSE it is shutting down. The switchover or shutdown could be due to either of the following: (1) The
operator is taking the action to switch or shut down the system. (2) The system has detected a fault.
PRIMARY No action is necessary.
ACTION
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
7-20
"Process Manager: Sending Go Active to Process—Maintenance
7-74.
"Process Manager: Sending Go Standby to
7-74.
Chapter 7 Maintenance Troubleshooting
OL-8723-19